Groups Heaters with harness, fabrications as. Construction GCB-N

GCB groups N heaters are used in the vast majority of occasions, and represent our manufacturing standard for this type of flanged equipment. Its construction is based on the coupling of the junction box through a metal conduit, which is screwed to the flange and the housing. Resistance, are close to the flange, and connection of the same is facilitated by placing strips on the junction box. Thus, interconnected resistances are perfectly, for, once in the hands of the customer, it only has to do to get power strips. On the other hand, the seals placed between the flange and the duct, and between the duct and the box, possible to offer protection against dust and humidity up to IP-66, provided that allows the box, making them suitable for outdoor work.

This construction gives the product a simple assembly and optimal handling for virtually any event. However, must take into account that the maximum heating temperature that allows the composition is 200 ° C.
Main Features
• Power to customer
• Three-phase supply to 750 V
• Specific load up 16 W/cm². Recommended loads by application
1 at 3 W/cm² – Air, stoves
1,2 W/cm² – Heavy fuel oil
2 at 4 W/cm² – Thermal oil, fuel oil or light media
6 at 8 W/cm² – Water
• armored elements in a "U"
• Material of the cover tube in stainless steel AISI 321, AISI 316L, Incoloy®-800, Incoloy®-825 ó Cobre Nickel • standard tube diameters: 8mm, Ø10, Ø12'5, Ø16 mm
• Longitude Llano Platinum maxim: 3300 mm for all lengths
• fully standardized Bridas: DIN – ANSI steel or stainless steel • Junction boxes with Degree moisture protection to IP-66
• Temperature Control by Thermostat, limiter, probe the thermocouple probe Pt100