Groups Heaters with harness, fabrications as. Construction GCB-C

The GCB-C heating groups are employed, in most cases the, in installations where the operating temperature is above 200 ° C. Its construction allows to separate the terminal area and electrical connection of the zone of action of resistance, thereby ensures that these areas are not affected by excess temperature. Also, in cases where the temperature is too, You can install heat sinks in the Thermal Area (E.T.) to promote heat dissipation and prevent overheating of the most troubled areas.

This type of construction is always more expensive due to the complexity. Is that why its use is recommended only in cases where the temperature does not allow us to use a standard production model (GCB-N).
Main Features
• Power to customer
• Three-phase supply to 750 V
• Specific load up 16 W/cm². Recommended loads by application
1 at 3 W/cm² – Air, stoves
1,2 W/cm² – Heavy fuel oil
2 at 4 W/cm² – Thermal oil, fuel oil or light media
6 at 8 W/cm² – Water
• armored elements in a "U"
• Material of the cover tube in stainless steel AISI 321, AISI 316L, Incoloy®-800, Incoloy®-825 ó Cobre Nickel • standard tube diameters: 8mm, Ø10, Ø12'5, Ø16 mm
• Longitude Llano Platinum maxim: 3300 mm for all lengths
• fully standardized Bridas: DIN – ANSI steel or stainless steel • Junction boxes with Degree moisture protection to IP-66
• Temperature Control by Thermostat, limiter, probe the thermocouple probe Pt100