Features
• Made entirely en Polypropylene tested in approved laboratories and tested against the effects of UV radiation and extreme weather. Highly resistant to corrosion, clohidros and other pool chemicals.
• Innovative technology for injection molding where the tubes and the heads become single piece.
• Flexible, allows eliminating the expansion and contraction ruptures and leaks.
• Most of the panels sold rest on the roof and having no ventilation moisture trapped beneath. This allows the formation of algae and fungi between the roof and the panel, with time, ultimately affects the roof. The design of individual tubes of the collector Heliocol facilitates constant ventilation under the roof panel, preventing moisture from collecting and remain.
• course, with your application over housetops, cooled stealing the heat from the sun and creating an insulating air half-chamber yet, step allows rainwater to be autolimpien, also protecting them from hail impact, especially in the case of roofs with bitumen protections antigoteras.
• Prevents the formation of snow on the roof thanks to the joint action of Thermostat Differential ALLEGRO 433
• The individual tubes Heliocol system gives way to the wind, significantly reducing stress on the fasteners of the roof panels.
• Low pressure drop reduces pump requirements.
• The unique design allows surround panel Heliocol any protrusions always ceiling not exceeding 25,40 cm. width. This prevents the installer from using more expensive items to save these obstacles and allows you to use more efficiently the available roof.
• If the panels are damaged Heliocol, can be repaired on the roof itself. This allows the repairs done quickly and easily.
Operation
The figure shows a solar heating system for swimming pools typical. Even if your system is not identical to that shown, illustration can help you understand the flow of pool water works through the pump, filter, Solar system and back to the pool.
1 Using existing circulation pump the water through the filter and then goes to the collectors.
2 Safety valve to prevent the reaction of water in the filter when the collectors are emptied.
3 Valve 3 Motorized routes Praha (against. 120651) automatically directs the water to the collectors when there is adequate solar radiation.
4 Ball valves to disconnect the solar collectors filter system in case of loss or when the solar heating system is not used out of season.
5 Vacuum valve for automatic drainage collectors after disconnecting the Solar System.
6 Entrance to the solar collectors on the lower side of the bank.
7 Outlet / inlet of the solar collectors to the pool.
8 Thermostat Differential ALLEGRO 433 who commands the motorized valve 3 pathways, Using two temperature sensors.
9 Outdoor temperature sensor, exposed to the sun by the solar collectors.
10 Temperature Probe, filter installed in the main tube to measure correct temperature of the pool.
11 Other systems: Support auxiliary circuit and accumulators.
